|
Done some more on the Oval-progressing with the injection.Made new throttle rods and doing the fuel rails.Using some extruded aluminium with small hats to go over the O rings on the injector ends.Couldn't find any fittings to screw into the rail,so machined up some Ally plugs and welded them into the rail.Can now thread them 1/4 gas.Drilled and threaded one T/B below the butterfly for the air temp sensor.Have to find a place for the one that will be in the oil.Have machined a Volvo 244 distributor and fitted a VW drive tang.It looks like a 009 and takes the same cap.Will T into the vacuum line going to the Auto for the MAP sensor and will make an adaptor the fit the TPS switch-a job for tomorrow.
|
April 13th 2007, 08:51
Threaded Mode