|
|
#3
June 21st 2007, 14:58
|
||||
|
||||
|
I was thinking something similar but without the cross drilling .I was going to machine the axle to a limited diameter then make a sleeve with an interference fit .Press the sleeve on and weld the end of the sleeve.Its just that welding affects the material and wondered if anyone had a better solution.
__________________
The wisest mind has something yet to learn 
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode