Spyder Bait

[Humble]

Been working on the bug more, working the kinks out of it. I kept having problems with the idle jets and it was getting worse and worse. I finally realized the jets had collapsed after being tightened too much. A new set of idle jets solved most of the problems I was having. I also adjusted the linkage so I'm getting full throttle now (not 2/3rd's like before) and the motor just races to redline from about 3k. I'm on my 3rd oil change, a little over 1700 miles on break in, and I'll be switching over to brad penn 20-50 now. While I was at it I picked up oil to do the race car too.



Now that the right front springs are in, a friend hooked me up with a free front end alignment on a new laser rack. We discovered that the front end has been tweaked a little bit so the smallest about of camber on the passenger side was -1.3*. The front toe was also way out from being lowered which killed my tires rather quickly. So the new specs are:

Front:
0* toe
-1.5* camber
1* caster

Rear:
0* toe
-1* camber

Since the tires were cording out it was time for a new set, but unfortunately Kumho stopped making the Ecsta MX in my size. In fact the number of good cheap tires in 205/40 17 has gone down significantly. So I stepped up to the next size 215/40 17 and got a set of Dunlop Direzza Sport Z1 Star Spec. Everything was fine in the rear but the front fenders needed a bit of massaging. It's a little rough and track rat/drifter looking now but the fenders needed a respray any way. Now I think I know the secret origin of the euro flared fender look, elbow grease and pliers.





With the motor at 100%, alignment done, new sticky tires and enough clearance for full suspension movement, it's just an animal on the mountain roads. As soon as I can afford a new camera mount I'll get some new in car video up