|
|
#3
March 2nd 2011, 08:18
|
||||
|
||||
|
Doesn't the wiring loom travel down the A pillar and then along the heater channel flange to the rear/ It does on our RHD 1303. It may be that the welder moved the lom out of the sill area but melted the wiring in the door post. Its worth a check. I bet he would have ensured that the horizontal part of the loom was far enough away from any heat - wouldn't he?
Clive 
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode