|
|
#17
May 20th 2012, 08:07
|
|||
|
|||
|
JULY 2011
engine out  Welded supports    fitting the gearbox  engine in place   I fit the seats and connect the driver one  engine and gearbox  replace H4 bulb by HID bi xenon   rads in place  dashboard mod  problems on the exhaust...  fuel tank mods   T3 parts  small panneling for the ecu and the sub wiring harness  water gauge sensor   the exhaust after cutting and correct rewelding  in place   too low , so cutting and welding   another in place   good  :mrgreen:panneling  the gauges in place 
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode