Dave's 1971 1302 Not-So-Secret, Secret Project Build

[owdlvr]

Well,

Started cracking down on the various things I need to address before rallyXing the car on the 24th. First up was swapping the Oil pressure gauge with the Voltmeter. Let this be a lesson to everyone, before installing everything else in front of the dash (wipers, airbox, etc.)...put the steering wheel in and make sure you can see everything! Now with them swapped I can monitor the oil pressure without the need to look, and I can see just enough of the voltmeter needle to know if it's charging or not.

With that done, i decided to investigate why Fuel Pump #2 wasn't working. It hasn't worked since the first day I put a battery to the car. I recall testing the relay and all the wiring I could reach, and determining at some point that it had to be the wiring right up at the switch. Since the dash was apart I pulled it all out, and found the switch and wiring to be fine. Hmmmm. Testing all down the line I eventually discovered I bought a $30 dead fuel pump relay. Hmph. Tossed a regular relay in for now (which doesn't have the tach-input feature) and Fuel pump two was working properly. Sweet. Stuffed everything back in the dash, put the airbox back in, did a few other things and triple checked it before leaving the garage. Fuel pump two not working.

Hmph. Guess I'll be going back to deal with that tomorrow night :P

I decided since I'll be working on it tomorrow that I might as well drive my F150 for a day, and put the bug up on Axle stands. It will give me a good chance to look everything over after playing the gravel for over an hour on the weekend. Good thing I did!


My first thought was that I must have blown a Motorsport CV boot. But upon closer examination it would seem that my catch can drain came loose and the oil was being picked up by the airstream from the tire. The drain is right against the inside of the fender wall, and will need to be changed. The oil tank was slightly overfull before I hit the gravel, and I knew the catch cans were going to need draining...but I guess the bug decided to drain them a little earlier then me. Unfortunately it's all over the brake caliper:


And the inboard brake pad is wasted.


I've got the brakes and rotor cleaned up, but will need to check to see if I have any rear pads for the car. I know I have spare fronts, but not sure about rears.

...on the plus side, at least I have something to do?!

-Dave