fitting mallory or MSD distributer with porsche fan

[powerbug]

Hi Brent

With regards to fitting the MSD dizzy when I mentioned that you can cut a part out I meant on the left steel strap that holds the fan down.
Made a small schematic to help you out.



Although your shroud and the block that the fan sits on may have been produced in NZ I don't think they differ that much from the ones sold here at Europe. After all they are all pretty much copies of each other!!
Do you have a picture of your shroud and fan bolted together along with 009 dizzy?

Wrt to the quality of the trigger system that CB sells it is very good. Have a couple of friends that use it and they had no problems with it.

Another system you might want to look at is the one from VW Speed Shop in the UK and it's this one

http://www.vwspeedshop.com/product.p...cat=494&page=1

[brent]

Thanks for that Powerbug, yes i see how you have cut a hole in the strap now, The picture helped thank you. I will see if this offers me enough room to fit larger dizzy now., I also looked at the other crank trigger system you suggested, definately another option for sure.. Tried 3 times to load picture.. I seem to struggle will get me son to attemp.

[powerbug]

Brent

One easy way to upload a picture is to upload it first to a hosting company's site like imageshack or photobuket. Once uploaded there copy the direct link they will provide for the photo and paste it here like this
[img]......direct link........[/img] and it will appear.

[itHaKa]

Do you have the sharpbuilt 911 kit from Australia ?

[brent]

Not sure, if you go through one of my old threads...1303 steet legal race car in NZ, there is a picture or two showing rear of my car. It is many yrs old but i still have the same shroud. Cheers Brent