Weekend racer/ dragster project.

[tom'72]

Can you give me some details on how you went about installing the side scoops?

I first made a cardboard template of the scoops shape and then made that about 1cm smaller all around.



Then I positioned that template on the body and cut it out ( this hole is now 1 cm smaller all around then the outer dimensions of the scoop.
Then I used a special type of pliers (have no idea how it's called in English) to make the body pannel where the scoop will be glued over fall just a bit deeper (think its 2mm) then the rest of the pannel so the scoop sits flush in the body.





You can see how the edge where the scoop will be lies a bit deeper here.

[tom'72]

The scoops are glued in place and I used a black sealent (looks and feels like silicone) to finish the outer edge ( am going to do that again as my first attempt wasn't as good as it should be).

[SilverBullet]

The rear wheels out alittle would be nice

[tom'72]

http://www.youtube.com/watch?v=0XH4vFT4AX8

Hopefullly will be able to finish up suspension, gears, clutch and gas cable + lots of other bits that need tidying op over the next week or so and then take it for a test drive

[excello]

WOW
That made the hair in my nek stand up. Nice!!!!