#1
|
||||
|
||||
F/S - Kennedy Eng flywheel T-4 Conversion
Have a look at this BEAUTIFUL piece of machining
Kennedy Engineering flywheel was purchased for a T-4 to T-1 conversion. I'm going another route so here it is on the chopping block. The hardware and pilot bearing are included. Purchased for $ 250 new. Paypal me $ 125 plus shipping and it's yours! Thanks for shopping in my garage. |
#2
|
||||
|
||||
O.K. O.K. I know you all want this....I'll change the price to $ 125 delivered in the continental USA
|
#3
|
|||
|
|||
do you still have this?
|
#4
|
||||
|
||||
Yes I do still have it.
|
#5
|
|||
|
|||
Just out of curisity, do I need a special pressure plate to go with it?
|
#6
|
||||
|
||||
No. It is from Kennedy Engineering for the T-4 to T-1 gearbox conversion.
|
#7
|
|||
|
|||
Sweet, alright, I just bought an engine... so give me a week or two to get the money and I would love to take it off your hands.
ERIK |
#8
|
|||
|
|||
I bought a type 4 2.0L for my 65 notch.... Will I need one of these to complete the conversion??? I am just getting started... any help would be good. Joel
|
#9
|
|||
|
|||
flywheel
Do you still have the Kenendy flywheel? Eric.
|
#10
|
||||
|
||||
Yup. It's still hanging around
|
#11
|
|||
|
|||
flywheel
Thanks for the quick reply. How much? I would pick up since I am local. Eric.
|
#12
|
||||
|
||||
I apologize folks.
I just checked my invoice from Kennedy Engineering and the flywheel is for a T4 - Porsche 915! ooops! |
#13
|
|||
|
|||
I'll take it, pm me your # so we can set up payment.
Thanks
__________________
Richard |
#14
|
||||
|
||||
Just to make sure we're clear Richard. It's a Kennedy flywheel for using a Porsche 915 transmission with a Type 4 engine.
|
#15
|
||||
|
||||
If Richard does not take it, I will.
Sandeep |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|