70Turbobug´s 2 liter turbo

[70Turbobug]

I´m sure it won´t take long before become that nutty aslo

[70Turbobug]

You´re right about turbos loving high lift,I might trade it in for my original choice the webcam 163.I haven´t really decided yet.I like the 86a because it´s a "quiet" cam and easy on the valve train and still pull to 7K.As you know choosing the right cam is always a challenge.What doesn´t make it any easier is following your experiences and seeing and driving with Armin´s 2 liter turbo with a low (11 mm) cam and the performance that his engine has.It´s actually not that spectacular riding in Armin´s turbo and you think at first it´s kind of a pooch,then you glance over at the speedo and you´re doing 260K/mh.His car doesn´t have the snap or agressivenesse that we see with the type 1s i.e. 2276 or so.But it´s just incredibly fast.It´s a ticket magnet...

[Wally]

Well, your the builder, you must choose eventually

[70Turbobug]

A very small update: The CU heads are back from glasbead blasting.To my surprise,they are in much better shape than I thought! Today they are getting shipped off for porting,seats,valves etc.

[70Turbobug]

Another small update.The case work is finished.The mains had to spindled out to 0.50mm.Now I will clean the case up a little better and then install the Raceware headstuds.

[Wally]

Good progress!
What are those weird looking copper-coloured thingys sticking out from under the bores?

[70Turbobug]

Originally Posted by Wally

Good progress!
What are those weird looking copper-coloured thingys sticking out from under the bores?

Oil squirters to cool the pistons.Simple but effective

[Wally]

Thought so, but how are those fixated? Mine sit much higer up and into the bearing saddle.

[70Turbobug]

The saddle is tapped and the squirters are screwed in.The squirters are the tips from a wire welder.I´ve seen others use grease nipples/fittings aswell.

[Xellex]

guys, what size do you think is best for the hole in the squirters? And do you have a closer look picture of them?

[70Turbobug]

There are different options.My case uses the tips from a wire welder with an M5 thread.Location and angle are the key to make it work properly,though.

[Wally]

Xellex,
I use the squirters from a 911 turbo. Those also have a check valve inside so your oil pressure doesn't drop at (hot) idle. They open at 2 bar or there about

Mark,
Did Remmele install these for you?

Tnx,
Walter

[70Turbobug]

Mark,
Did Remmele install these for you?

No, Remmele uses the Porsche squirters also IIRC Most of his engines do not have oil squirters.Armin did the casework - it´s one of his cases I bought from him.I gave him my case as a "trade in".So he deserves the merit on this

[70Turbobug]

Another small update - my billet single stage dry sump pump from Thorsten Pieper came in.It has a 3 piece housing with 32mm gears.

[Xellex]

nice! Can these be ordered online? I only found vague information about thorsten pieper on the web.