|
My cylinders
Good afternoon, I dropped off my cylinders to brothers for them to do the final honing for 103mm bore. I needed them to also re-position the stud pattern. I have heard very little on the subject of plasma coating. Since I know nothing on this subject is there anyone out there that can say that, that technology is better than the nickel seal coating . Nickel seal coating from U.S. Chrome is quite pricey per cylinder. However if there is a newer technology that offer the same hi protective ability when applied to aluminum, I'd like to know and utilize it.
Last edited by effvee; August 12th 2016 at 03:44.
|
July 30th 2016, 18:54
Threaded Mode