|
|
#1
February 5th 2007, 17:23
|
||||
|
||||
|
Flat! Rear 944 set-up
Hey lanner,
I know the rear 944 hubs are what increase the track by 24mm per side on a beetle. Is there any way to machine the hubs so this offset is minimized? I want to use them on my beetle, but the increase in width will not comply with my stock fenders, even when I take my spacer off that I am currently using. It's a little different process than the fronts, but I was just wondering if there was any chance. Thanks.
__________________
^^^^^^^^^^^^^^^^^^^^ [SIGPIC][/SIGPIC] 1302 Super (O\!/O) 
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Threaded Mode