Front Suspension Question on my '68 T1!

[German68Air]

Hey everyone,

This is my first, official post here and I am very excited b/c this forum is awesome!

I have been working on my '68 Sedan, off-and-on, for a little while now. I have M7A discs all the way around w/ the vented, x-drilled, and grooved rotors in the front. 17" Turbo Twists are the rims/wheels I am running w/ a 3" narrowed RLR ball joint front beam (I am still deciding on tie rods; most likely VDub Engineering).

I have been looking at Red9Design's coil over kit for a front and rear suspension option, and I believe the Whiteline front sway bar from Aircooled.net. However, this setup would be very expensive b/c of S&H and currency exchange! In all, I am looking for a sweet suspension setup that will accommodate my 2110cc stroker motor; which is in process of being built.

Any great recommendations?

Thanks for your help.

[zen]

you are on a great course if you have the budget for that. if you don't, you might pass on the coilovers and just go with quality sway bars as planned.