|
#1
|
|||
|
|||
A couple questions about a 993 Brake conversion
I need some info on how to mount 993 calipers and rotors on the rear of a 1969 standard bettle irs set up. What machining is required, can vdubengineering do it, how much does it cost, what parts do i need to buy,
already have the front mounts figured out ( i'm going to go through vdubengineering for that onces all the parts arrive) also what should I do for a master cylinder setup? Thanks guys |
#2
|
||||
|
||||
Have you tried a search in the brakes section? This has been covered quite a few times on here.
__________________
1970 T1 W/MassIVe 2913cc RAT/?EFI? w/direct fire (very soon) and 915 trans 1962 SC 1776cc SP 944NA brakes, 993 wheels VKG |
#3
|
|||
|
|||
i've been going through pages and pages but nothing on how to set up the 993 rear brake set up...
|
#4
|
||||
|
||||
I'm going a 993 front and rear set up also and I'm also going to have Lanner machine the fronts too.
For the rear I'm going with 944 n/a hubs, the mounting plates for the calipers, and the ebrake hardware. If you put the 944 rear hub, 993 caliper and the 993 disk it will all work together. You will need some small spacers made (about 3mm) to center the caliper on the disk.
__________________
Mike '04 R32 Tornado Red '02 New Beetle TDI - Daily driver '64 Ghia - Project!!-Subaru EJ20T, MS/EDIS, 993 brakes, 914 Tranny... |
#5
|
|||
|
|||
okay awesome,
see i have info on doing a 944 upgrade but not the 993, so pretty much same as a 944 but you use 3 mm spacers correct? |
#6
|
||||
|
||||
Straight from VdubEngineering's site...
Quote:
__________________
Mike '04 R32 Tornado Red '02 New Beetle TDI - Daily driver '64 Ghia - Project!!-Subaru EJ20T, MS/EDIS, 993 brakes, 914 Tranny... |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|