#1
|
||||
|
||||
Best way to run a speedo cable w/Porsche brakes
In looking at my spindle / brake / hub setup. I can barely fit the center cap of the wheel on which means a dust cap that will allow me to run the stock speedo cable is a pipe-dream.
Is this a case of narrow the beam then run spacers to get my track back but will allow me to put the dust caps on to get a speedo that works? AAAAARRGGGHH! |
#2
|
||||
|
||||
I had to dent the end of my bearing cap in to get the speedo cable to fit. Also had to sand the tip of the cable off a bit. There should be room to do both.
__________________
NO_H2O 72 1302 Smack Black GL 73 Bus (2L CIS Powered) 66 Beetle, 73 Standard Beetle 72 Pinzgauer 710M Volksport Kafer Gruppe |
#3
|
||||
|
||||
I cut a ring section of the cap out and welded it back together, no problems and plenty of clearance internally to the nut to do this..
__________________
http://www.ricola.co.uk |
#4
|
||||
|
||||
my 1985.5 944 set up
has a hole for the cable! |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|