|
#1
|
|||
|
|||
Hello everyone,
Well it's good to see someone makes them. Question, have you seen the Pete Fusa rockers? I'm am not sure that they are for type IV heads though, I will send a e-mail and hope the answer is yes. |
#2
|
||||
|
||||
Quote:
Unfortunately, the Weiss rockers are very expensive (double what Pauters used to cost iirc, about 850-895 euro's?) and you need their billet valve cover since their rockers sit very high. Another 300-350? I think you might be well over 1200 euro's for just rockers and valve covers... I think Apfelbeck parts might not be that expensive after all LOL! |
#3
|
|||
|
|||
Good morning,
The rockers I showed were 1.7 ratio. I believe that they are not type IV also. I emailed him because, if a company can make that quality of a part, hearing his yes or no on possibly endeavoring to make some is worth at least asking the question. 1200 euros is high. Last edited by effvee; May 12th 2020 at 17:25. |
#4
|
|||
|
|||
Type IV rockers relpy
Hello everyone, please see the reply concerning the type IV rockers.
Hi there On my website the rockers are typeV . It's not the same of pauter ok. I already produced type 4 of pauter, I can do this without any problems. I need a minimum order of 5 sets. Value per sets of $ 650.00 Total $ 3,250.00 Question, is there enough members to place an order? I sent another picture of his rocker arms for him to validate. I also sent a picture of my engine, as the type IV, to make it clear. I believe Pauter started to have problems with reliability of his product. When I see Fusa product, it reeks quality. Because Brazil speaks Portuguese I am trying to make my point clear. |
#5
|
|||
|
|||
Latest Reply On Fusa TypeIV Rocker Arms
Hello,
Presently I don't have the funds. However, just as soon as I am able I'll get some. |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|