#1
|
|||
|
|||
Rear lowering: how much is enough
Hi,
I`m wondering how much I should lower my car to achieve a camber of about 1 degree negative. 1 outer spline too much? Table of lowering vs spring plate angle http://www.glenn-ring.com/temp/splines.jpg Pic of its current stance. http://blogsimages.skynet.be/images_...6813a44bff.jpg |
#2
|
||||
|
||||
to be honest, every car is slightly different , my irs setup was 1 spline 25mm and 2.5degrees on one side and 3 degrees on the other but turning the a arm on the spring plate got it back to 1.5 degrees both sides , there is a thread on here about doing this
hope this helps j
__________________
woop woop 67 2276 turbo 64 ghia 1776 zx7rr |
#3
|
|||
|
|||
This is a swingaxle setup so that would differ from an IRS setup.
Am aware that no one can give me an exact number, but a rough guideiance woiuld be appreciated. |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|