#10
|
||||
|
||||
I knew if I wrote enough, there must be something that makes sense now and then
Cheers guys Anyways, I finally remembered a little thing that was almost forgotten: maching the flywheel for the central pinion bearing... Got that done today, so finally the flywheel and clutch are on the engine. Also bought a set of new CV's for the outer sides only as these Lobro/GKN ones are quality but 4x as expensive as chinese Empi ones (assuming those are the cheap ones). Hopefully I can finally put the engine in later this week and finish the install over the weekend. |
Currently Active Users Viewing This Thread: 865 (0 members and 865 guests) | |
|
|