|
yeah but the stick out on all 4 corners, frontend is like yours in your picture. the rear is bout half that.I thought bout using them but there 4.5" wide, if I build a hi po motor they might spin alot. Also they got a 0 offset and I dont think ghia discs will fit behind them.
I do have and idea for them but donno if it would look right. If I did use these, Id narrow the front 2" maybe that would be enough to allow me to lower the front 3" and then for the rear, buy 1 1/4" wider fenders to cover them fully and lower the rear 1 or 2". If i could maybe theres a tire that would fit better than a 195/60 does, they kinda balloon out but not really bad.
Last edited by Veedub; March 21st 2007 at 02:01.
|
March 21st 2007, 01:57
Threaded Mode