|
|
#16
July 12th 2007, 08:43
|
|||
|
|||
|
I've been chasing the same issue for two weeks -- and just now found this thread.
 I've got a BJ Beetle with new CB 2.5" narrowed beam and drop spindles. The RHS is +/-0 degrees with the stock eccentric bushing set to neutral and the best I can get on the LHS is +2 degrees with the eccentric fully cranked. I can get to +1 degrees on the LHS with an aftermarket eccentric, but want -1.5 degrees. The springs pocket grub screw locations are correct (sides to center). Looks like I need to double-check the beam... 
__________________
Kafer_Mike Build 'em fast...or let 'em sit. Last edited by Kafer_Mike; July 12th 2007 at 08:46. 
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Threaded Mode