17" for my buggy

[jonas_linder]

Just got my backrims back from some machinework

http://www.vwairheads.org/e107_plugi...bum&albumId=81

[Racelook]

Nice

You had them widerened? How wide are the wheels now, and what were they original?

Wiebrand

[coffinator]

Where did you get the work done?

[jonas_linder]

Yes, they are 3" wider now, 10" total!

I had it done by www.falgrikt.se a Swedish company!

[oicdn]

Intresting...my question is besides how much it cost USD....is, although it doesn't matter when the tire is mounted, but is it still a safe wheel to roll on for the street?

I'm just thinking, that's a mighty big lip, it kinda throws off where the stress is usually distributed....since it's so deep, it looks like it might actually break if impacted hard....

Looks nice, a little too deep for my taste, but sick as hell none the less...

[jonas_linder]

Originally Posted by oicdn

Intresting...my question is besides how much it cost USD....is, although it doesn't matter when the tire is mounted, but is it still a safe wheel to roll on for the street?

I'm just thinking, that's a mighty big lip, it kinda throws off where the stress is usually distributed....since it's so deep, it looks like it might actually break if impacted hard....

Looks nice, a little too deep for my taste, but sick as hell none the less...

The cost is 2500 sek per wheel(for 3" wider).. thats about $335 (1 kr = 7.52 $ )

The wheel is welded with TIGed from both sides on both seams and should be just as strong as before! It moves the ET from about ET 35 to ET -41 ..

I wanted the fatliplook for my buggy at the rear