|
|
#1
November 30th 2005, 13:50
|
|||
|
|||
|
Fitting a CSP Kafer Brace
Any body modifications required to fit a 3-bar CSP Kafer Cup Brace in a '69 Bug? I remember reading about needing to remove some metal around the shock towers, but don't recall the specific application.
Also, any clearance issues with the CSP bar and a A1 Sidewinder header?
__________________
Kafer_Mike Build 'em fast...or let 'em sit. 
|
|
#2
December 1st 2005, 12:31
|
||||
|
||||
|
Just som small clearancing needs to be done to the sheet metal to make place for the upper brackets.
__________________
Check out my project pic`s! http://www.v-dubs.no/haraune
|
|
#3
December 2nd 2005, 10:24
|
||||
|
||||
|
same experience here. just on the right side though. very small notch.
__________________
zen '73 2316 TIV GL Standard Bug (quasi) Company Branding, Graphic Design, and Web Services at DigiVinci Design
|
|
#4
December 2nd 2005, 12:32
|
||||
|
||||
|
Same as above, small amount of notching required. 30seconds with an angle grinder and its done
 Sam C
__________________
1973 1303 (super beetle) in Jaguar British racing green, Raby 2270, B spec gearbox, Lots of carbon fibre, Wolfrace Octane Black 17x7.5, Goodyear Eagle F1's, Kerscher suspension front and rear, kamei airdam in carbon, corbeau seats, momo millunium steering wheel. CDT eurosport 6.5 front speakers, IDMAX 12D2 sub, rockford old school amps.
|
|
#5
December 2nd 2005, 12:50
|
|||
|
|||
|
Whew! Thanks guys. The car is in for paint and I was having nightmares about having to carve up the wheel wells...
__________________
Kafer_Mike Build 'em fast...or let 'em sit.
|
 |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
