|
|
#1
July 25th 2002, 19:26
|
||||
|
||||
915 box to T1 engine
Has anyone mated a 915 trans to a type 1 engine. I see it alot with T4's, but not with T1's. I understand that Kennedy makes a flywheel for this conversion. I think I can handle the mounting. The "push type clutch" worries me though. I plan on using a hydraulic set-up. Any tips or suggestions about this conversion would be greatly appreciated. Thanks!
|
|
#2
July 26th 2002, 14:08
|
||||
|
||||
|
My engine is in the states being built by Marty Staggs who bought the Kennedy Flywheel which uses the porsche clutch.
Box is a 915 but I haven't used it yet.
|
|
#3
July 26th 2002, 17:20
|
||||
|
||||
|
Thanks dude. I just got off the phone with Kennedy. My flywheel should be here in about a week. I still have the "pull type" clutch problem though.
__________________
Julian '74 Super "If you are under control you're going too slow" - Parnelli Jones
|
|
#4
July 31st 2002, 20:20
|
||||
|
||||
|
I've just got a line on a trans. I'm hoping to post the install as soon as I can find time to install.
__________________
Julian '74 Super "If you are under control you're going too slow" - Parnelli Jones
|
 |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
