|
#1
|
||||
|
||||
Wally dry sump tank on this engine would you recommend it's use on a t4 or waterboxer engine.
|
#2
|
||||
|
||||
I dunno, it seems oddly shaped and I think its crazy expensive if you had to buy a used one. Why would you even want to consider that? Strange question?
Anyways, trying to find the correct starter motor for this combo, so I can test compression, is a test of patience..I bought a wromg one, hopefully coming week I have the correct one here. Fortunately the chinese electrical parts are cheap and usually work just fine (1303 has one too and that one works awesome!). In the meantime, the 'project creep' has gotten to the front brakes Did make sense to up that area a bit more, so the CB alu wheel bearing houses with 5x130 studs and disk/calipers are for sale now. This was a lot more work: epytec wheel - 944 outer, type 1 inner - bearing housings, boxster calipers and cayman 299x20mm disks, plus adapters from Lanner: |
#3
|
||||
|
||||
So you purchased the Epytec hub and bracket kit? How well made were they?
Are you using their bracket, or are you using something you fabbed up? |
#4
|
||||
|
||||
Just the hub; Lanner made me a custom bracket for type 3 (as the steering arm on the spindle is always in the way) and my particular set of parts
|
#5
|
||||
|
||||
How would you rate the quality of the hub? Will it endure your track usage and such?
It uses the standard VW spindle which means no special machining and such correct? I'd like to get a set for my '70 Ghia, but I've got 944T brake calipers. |
#6
|
||||
|
||||
Quote:
Yep, fits standard VW type 1 wheel bearings. However, its meant for stock 944 front disk and everything else will be custom. This is of course trivial info, but just realise this. Only thing that didn't work for me with these hubs is the hole for the Porsche studs: its too small for my taste; its like 14,2 mm, while the studs have ribbed splines with 14,7 or 14,8mm outer size. They fit too tight then, so I drilled the holes to 14,5mm and now the interference fit is much better and they press in easier, still quit some force is needed, but as the material they used is superstrong, the interference fit can (needs) to be a little less extreme (which it was originally). Other then that, you also need a special seal on the inside (not in the kit) as the VW part doesn't fit and you will also need the stock 944 hubcaps and your left one with the speedo opening. So, very high quality, but its no buy and run it same day thing. It never is though when using Porsche brakes is my experience ;-) |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|