#16
|
||||
|
||||
Porsche spacesavers
Porsche spacesavers.The 15" silver one on the left is P/N 951.362.131.00 and the 15" red one in the middle is P/N 951.362.130.01. The red one pictured on the right is a 16" alloy wheel with P/N 965.362.130.01.
|
#17
|
||||
|
||||
I have two red 17" space savers as well. I use them only fro drag racing.
Stock they have a 105/95/17 tire with an 'M' speed rating (160 km/u max iirc) They are 3,5"x17 ET19. Really need the part number? Rears are the 5,5x15 specimens, just for drag racing used here: Last edited by Wally; July 1st 2008 at 15:15. |
#18
|
|||
|
|||
hello
you people using the 15" space saver wheels are using them with 4 pot brembos ok? do they clear ok because i was under the impression that you needed to use 16" and bigger wheels to clear the 4 pots? mabbo |
#19
|
||||
|
||||
There is no general '4-pot Brembo' as there are many types and they all come with different disk sizes as well...
To my surprise I did manage the 15" spacesaver around my former 302x32 disk with the huge 928S 4-pot brembos, so my guess is they clear more easily than most other rims, but no guarentees whatsoever. Rears usually always clear. I now have 299x24 with the 993 rear caliper and that clears fine as you can see in the picture above. |
#20
|
|||
|
|||
Cheers for that Wally,
I read the 'which 944 conversion' in the tech articles. The 1st method was to use a Kerscher rotor, CB dropped spindle, and 4 piston 944 caliper. Now, after searching on here i think i remember people saying you must use a rear caliper as the Kerscher rotor is only 20mm thick. Id like to go for this method i think, as there is next to no machining, and everything apart from caliper will be new. If I did this method, I assume the 944 rear 4 pot is one of the smaller ones so maybe I could use these under 15" space saver wheels? Mabbo |
#21
|
||||
|
||||
My guesstimate would be yes, but no guarentees as I have not done exactly that myself.
|
#22
|
|||
|
|||
cheers for that wally, i appreciate it
ps - your car rocks |
#23
|
|||
|
|||
Here's my 996 spare in my 1302. Lots of room, even for my new triangulated strut brace in the works....
Lanner |
#24
|
||||
|
||||
Excellent shot.. thank you very much!
__________________
My newly Updated Webpage..that actually works now!!! |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
Thread Tools | |
Display Modes | |
|
|