#1
|
||||
|
||||
kafer brace
lanner,
i was wondering hows that kafer brace going? rip
__________________
Rip H. Van Winkle "The Ultimate Sleeper" |
#2
|
|||
|
|||
Almost there.
Basically, it'll be weld-in like the CSP one. I can't make it bolt on without compromising strength or going crazy on the design (ie, will cost alot). I'm using brushed stainless tubes, with aluminum ends. Roughly speaking, the 3 bar will be $C280, and the 5 bar will be about $C380. I'll post some pics when it's ready to market. (The front Superbeetle 'x brace will use the same components, stainless tubes with alum ends...also coming soon.) Lanner |
#3
|
||||
|
||||
__________________
'72 super '65 bus '52 split |
#4
|
||||
|
||||
Lanner, think they'll be ready in two weeks? I'll be up that way again. I could stop by and pick one up. Save you time on shipping. I'm interested in a 3-bar brace.
I'd like to come by and check out the shop or something. I should be in Hamilton for about a week or a week and a half. Havn't decided yet. I'll be spending time with my girlfriend, but I could talk her into going to your shop. I've got her hooked on Vw's now.
__________________
Mike '04 R32 Tornado Red '02 New Beetle TDI - Daily driver '64 Ghia - Project!!-Subaru EJ20T, MS/EDIS, 993 brakes, 914 Tranny... |
#5
|
|||
|
|||
Mikey,
I'll give it a shot but the odds aren't good. I'm packed for the next little while. As for coming by the shop, there's nothing much to look at. I work out of my home garage and do the dirty work (ie machining) at the day job. You're welcome to come by and shoot the sh!t. Maybe life (and business) will get better and I'll get myself a serious shop. We all gotta dream right? Easy, Lanner |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|