GermanLook Forums  

Go Back   GermanLook Forums > Articles > Technical Articles

Reply
 
Thread Tools Display Modes
  #1  
Old May 3rd 2010, 17:15
zen's Avatar
zen zen is offline
Registered User
 
Join Date: Jul 2002
Location: atlanta, ga
Posts: 2,946
Removable Rear Valance

by Sam C
Nov 20, 2003



Very simple really...

1. Drop rear wings off
2. Remove engine bay lid
3. Remove engine
4. Eyeball the rear, work out where you can easily cut such that it will go back together (With brackets... Flat bit of thick metal with holes in)
5. Draw on the car where you will cut. Make sure its the same both sides.
6. Get your mounting plate, with about 6 holes in it (3 per side). Position plate where it will go to hold the rear end on.
7. Drill through each hole, and then put a nut/bolt on one by one. I used Stainless steel M8 bolts.
8. Remove the plate when all done. This means that side when bolted back together will be in exactly the same alignment.
9. Get the grinder out and cut straight down on JUST the one side.
10.Use a file and clean the edges if needed.
11. Repeat steps 6-9 for the other side.
12.Bolt the rear end back on with the plates and check it looks fine
13.Paint/rustproof any bare metal.
14.Bolt it all back together

Simple as that
__________________
zen
'73 2316 TIV GL Standard Bug (quasi)


Company Branding, Graphic Design, and Web Services at DigiVinci Design
Reply With Quote
Reply

Tags
rear apron


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 19:51.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
© www.GermanLook.net 2002-2017. All Rights Reserved