#1561
|
||||
|
||||
Wally,
How much ground clearance do you have with the exhaust header setup the way it is? |
#1562
|
||||
|
||||
As the car sits now (I just measured for you) almost 5 inches (12cm). Silencer is a little over 4 inches..
Last edited by Wally; April 25th 2020 at 08:57. |
#1563
|
|||
|
|||
[/QUOTE]
Now I see which way it is going. Cool design
__________________
VW Super Beetle 1303 1973 Kolibri Grün Metallic |
#1564
|
||||
|
||||
Hi Wally
Looking good. Is that an OEM oil cooler or an aftermarket one? Does it fit behind the rear apron without any modification? I'm asking because I'm yet to source an oil cooler for my sons Beetle. Steve
__________________
STI powered 1303 in the works. |
#1565
|
||||
|
||||
Wally, what do you use for lines for the oil cooler, and how have you routed them? -10AN I'm presuming?
__________________
'71 Type 1 - Rally Project '58 Type 1 - I bought an early!?! '73 Type 1 - Proper Germanlook project '68 Type 1 - Interm German 'look' project '75 Type 1 - Family Heirloom '93 Chevy 3500 pickup - Cummins Swap |
#1566
|
||||
|
||||
Quote:
The guy in Poland had 2 or 3 of those... It fits so snug directly behind the front apron and the spare wheel well, that I didn't even need mounting tabs or something! I just ty-wrapped it to both outer grill mesh holes Oil feed from tank in the nose to engine is AN12. Oil suction and back to the front oil cooler and then tank is just 1/2" (13mm iirc) inner diameter oil line. No problem like that for over 13 years now with all engines |
#1567
|
||||
|
||||
For those that don't do FB or STF, I got the engine on the dyno yesterday and it did even better then I expected!
244Nm @6K and 226,5 CHP @ 7K with the low CR engine with air filters, muffler and horizontal fan belt running up to 8K made me very happy https://www.youtube.com/watch?v=LKhbYc0gOGY |
#1568
|
||||
|
||||
nice
__________________
STI powered 1303 in the works. |
#1569
|
||||
|
||||
Just a pic from early this year just out of hibernation ;-)
|
#1570
|
|||
|
|||
Walter, I love your 1303
Granted, I am a bit partial
__________________
johnL (aka H2OSB) '74 1303, Outlaw sedan (with a GL flavor) |
#1571
|
||||
|
||||
Haha! Thanks man!
|
#1572
|
|||
|
|||
Yep..
Just wanted to chime in that i read the whole thread again over the last few evenings.
Thanks for the inspiration. |
#1573
|
||||
|
||||
Haven't been here in a while, but for those still here: after the re-install of the whole turbo set-up, it made 475 hp at 1,6-ish bar boost on gasoline, 0% Ethanol, gas (the higher octane of course) bought at the pump here in Netherlands.
At Santa Pod I finally reached my long time goal and it ran a 10,58 seconds in the 1/4 mile at 130mph! Way more then I anticipated. I drove there, camped at the track and drove back home again on my own wheels - as I had always planned. https://www.youtube.com/watch?v=9LI-_7aQIIw Last edited by Wally; November 11th 2022 at 14:32. |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
Thread Tools | |
Display Modes | |
|
|