Fitting a CSP Kafer Brace
Any body modifications required to fit a 3-bar CSP Kafer Cup Brace in a '69 Bug? I remember reading about needing to remove some metal around the shock towers, but don't recall the specific application.
Also, any clearance issues with the CSP bar and a A1 Sidewinder header? |
Just som small clearancing needs to be done to the sheet metal to make place for the upper brackets.
|
same experience here. just on the right side though. very small notch.
|
Same as above, small amount of notching required. 30seconds with an angle grinder and its done ;)
Sam C |
Whew! Thanks guys. The car is in for paint and I was having nightmares about having to carve up the wheel wells... :)
|
All times are GMT -4. The time now is 04:30. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
© www.GermanLook.net 2002-2017. All Rights Reserved