|
I'm having 034 build a harness for me, I think it actually uses the stock H2O temp sensor so that is taken care of, and then I can just set what temp I want it to come on at.
Pulled the motor and tranny out for the last time. Wanted to make sure everything inside the clutch was buttoned up OK, found that I had forgotten to tighten the bolts on the driver side CV!!! Double checking is a good idea apparently....
Welded up the gaping holes where I cut the frame horns off at the torsion tube. Engine back in then wait till new harness and throttle cable arrive from 034...
Jason
|