DIY Kafer Brace

[zeroaxe]

I did a search on "brace" and found a post on a CSP Kafer Brace in this section of the forum, so I am posting here too(correct me if I am wrong).

I have noticed that the braces that can be bought over the counter(or net for that matter) all seem to have some adjustability. Is this really necesary? I have not noticed 'solid' bars etc. Why is this?

Reason for asking is that I am considering making my own. Yeah sure, it can be bought, but if I can make it myself instead, I would do it. I like cutting, grinding and welding stuff. Plus I can say afterwards that "I" did it If I make my own, I would have a problem knocking up the adjustable part of the braces. You know, the part with the 'eye' amd threaded bar. Plus, I dont think that I would be able to buy 'wrong way thread' threaded bar(that is left thread right?) here in the DIY shops in France. Finding specialist shops that deals in these kind of stuff is difficult to find for me. IF I make my own, and adjustablility IS NEEDED, surely I can only make one side adjustable, no?

Any help and insight is much appreciated! :agree:

[super vw]

They dont HAVE to be totaly adjustable... but it sure makes building it and then instaling it easier.

The one i made was partly adjustable. i had the main cross bar that bolts to the shock tower non-adjustable, and tailored to fit my chassis. I then had the two droplinks that attach to the frame horns addjustable so i could add a slight (just till snug) pre-load. but it also makes instaling them easier.

You can buy clevis ends or heim joints in standard thread or left hand thread online. Summitracing.com or jegs i do think has them along with the needed "jam nuts" and weld in threads bungs.

[Bruce2]

If you are going to make your own, you could use old front tie rods. They have the left and right threads. You could cut the threads off the old tie rod ends and weld them to some steel tabs. Hunt the wreckers for tie rods that will be the right length.

[zeroaxe]

Super VW,

That is what I thought. I was thinking that only one side would have to be adjustable. I checked out SummitRacing, but the costs for getting stuff shipped to France will not make it worth my while, but thanks for the info anyway!

Bruce2,

Thanks for the tip. That is actually a very good idea! :agree: Just not 100% sure how I will weld tabs to the rods The other thing is, I think it would be difficult ot find bolts in the DIY shops here that will screw on onto the tie-end rods. Unless I get the whole assembly?

[Steve C]

Hi

Im going to use tie rods for my brace when I get to that point. The good thing is if you need to trim them down in lenght, if you only cut the right hand thread side you will only need to buy a right hand thread tap which are much easier to find and cheaper to buy than left hand thread taps.

As far as hooking it up the ends to the tie rod threads, you could either leave the tierod as is and weld a tapered section onto the anchor or just have some U shaped clevis ends made up and weld them to the threaded section of a tie rod after you cut off the nuckle.

Steve

[Steve C]

Hi

Also if you can have different thread pitches but still right hand thread at each end of a rod, this will give adjustable lenght as well.

Steve