Length comparison 915-shortnose G50

[Wally]

Originally Posted by Steve C

Hi Wally

Looks good, I didn't get a chance to get back to you with the dimensions, then the forum was down, look like you have it sorted.

I even thought about using the stock G50 fork and making it a push rather than a pull clutch.

Steve

Thanks Steve. Well, not sorted all yet, I am close, but not there yet wrt the min. height of the hydr. bearing. Your idea of maybe using it as a push type release may just be another good idea of you

Lee and Rich had another great idea as they told me that the front output shafts of the 4 wheel drive 964 (G64 tranny) fitted the G50 and were 100mm (944/T2 size)! So. if that works out, my problem of the axles looks almost solved :-))