|
|
#10
November 15th 2008, 12:33
|
||||
|
||||
|
We did a lot today. A friend helped out machining down the bellhousing, nachined the bellhousing a tad bit wider afterwards so a type 4 fits again flawlessly on the bellhousing and shortenend the hardenend splines on the main shaft:
Before:  After:     Case fits fine now:    Result is super! I only need to shorten the shaft myself now but that is not a problem.  Thanks John! :respect: 
|
| Currently Active Users Viewing This Thread: 38 (0 members and 38 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode