|
|
#1
September 17th 2002, 13:30
|
||||
|
||||
|
Carbon Fiber Type 1 valve cover
I just finished my first carbon fiber type 1 valve cover, please take a look and let me know you think.
Thanks http://photos.yahoo.com/bc/sunshine7....src=ph&.done= 
|
|
#3
September 18th 2002, 09:53
|
||||
|
||||
|
The resin I use can take temps up to 450 degrees this stuff is so tough that it can be machined and I can install breathers if needed. I've incorporated a lip along the inside that pushes the gasket out against the cover. I want to do some testing before I start selling them, I'm having a small problem with bails. The covers are taller than stock covers even tall then scat covers, so I need a taller bails, any one know were I can get some made?
Thanks, 
Last edited by Carbon Joe; September 18th 2002 at 15:12.
|
 |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
