|
|
|
|
#1
April 26th 2004, 23:22
|
||||
|
||||
|
cool, I'm going to find another set and make use of them, and I definatly want the front a bit lower, so i'LL make use of a set of dropped spindles as well.
__________________
a few pics of my project Last edited by Shadowbug; April 26th 2004 at 23:22. Reason: I'm just stupid, OK? 
|
|
#2
May 3rd 2004, 21:26
|
||||
|
||||
|
anyone know much about these calipers?
I'm wanting to polish them up but I had a question, the little nub below where MAZDA is cast into them can this be ground off? good sence would tell me that this might be where brakefluid travels connecting the two pistons on that side of the caliper, but if it is not, I'd just as soon grind it off for a cleaner look.
__________________
a few pics of my project
|
 |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Hybrid Mode
