Body off rest.

[Bill K.]

I've taken my 70 bug body off without bracing. I've flipped it upside down to replace the heater channel bottom plates and trucked it to/from paint shops on a pickup. I test fit it on the chassis and it seems straight. If you are replacing the heater channel or have rotten heater channels, then definately brace it. The body is alot lighter when you strip it before lifting. Take everything off and two guys can lift it and put it on standard saw horses. It takes 4 guys and beefy saw horses for the full body. Things are so much easier to work on when the body is off.

Attachments are of inversion to remove heater channel bottoms and of the body on the bed of a long bed pickup supported by side rails over the wheel wells.

[MattKab]

Have you ever seen a pic of Bug having the body dropped on a 'pan in the factory?

I recall a pic of a 'fully' assembled body (a red one, doors shut) being lowered onto a 'fully' assembled 'pan on a line.

Each body was suspended by 4 cords, each being 'hooked' to a wheel arch!

Don't try this at home volks...Not sure every Beetle was handled that way either

I'd love see that pic again..

Matt

[boygenius]

I have seen that photo and others photos of emplyees pushing carts filled with hoods and fenders. If they only knew what they would be worth today they might have taken some home with them.