i have an oval, and want porsche brakes, what do you reccomend??

[speedy]

there is a tech artical on a porsche brake king and link pin conversion , should point you in the right direction
jon

[buggyboyshane]

thanks guys

[buggyboyshane]

ha ha!!!!! ive justboughtfull setof brakes of a 2003 boxter 3.2 's', these are all four 4pot red calipers, with all pads, car only covered 30k miles. four crossdrilles disks, rear brake internals. for £350 is that good?

ok then....... where the fuch do i start?? wanna put them on a 56 oval chassis. i have cb dropped linkpin disk spindles. do i go old way and mill down a vw disk to act as a hub and mount onto porsche disk?

what about the rear? i take it i have to produce some sort of backing plate to mount the small handbrake shoes inside the rear hub again a milled down drum?

any help greatly appreciated

cheers lads

ps. whats the smallest rim size i can put on this motor, was hopin to run my 15 fuchs but poss. not gonna happen now.

[wrenchnride247]

PM flat, (vdubengineering) he can help with advice, or parts.

more than likely you will have to run 17's