#1
|
||||
|
||||
Lighten a 210mm flywheel ?
Hi All,
Did a search and can't find anything.... I am getting ready to install my 914 2.0 this weekend (just the long block). I've checked the endplay and have installed the correct shims and new seal. I need to get the 210mm bus flywheel and PP I have resurfaced... some pitting and some rust. The fly already has the bearing mod. Should I/ Can I lighten this flywheel ? what weight would be good ? Also, do I need that flywheel 'crush' washer (washer with 5 holes on it that fits between the fly and the 5 bolts with serrated surface) ? The application is stock 914 2.0 into '74 bug with 44 IDF's, Daily driver .... later converted to a 2270cc. Thanks for any responses. Sandeep |
#2
|
||||
|
||||
You can lighten it on the outside diameter, no special weight written down. Just take away from the outside to the screw threads, that's it.
Use everytime you rebuild a flywheel a new shim under the srews, it's for safety. If the flywheel was screwed on without this shim, resurface the surface where the screws sit, as it's mostly damaged through that!
__________________
Click here to mail me! |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|