my 56 money pit

Dasdubber · #1 August 20th 2006, 08:12

Hey Malcolm, good to see you over here on GL - enjoying seeing the progress of your project - keep them coming!

56oval · #2 September 11th 2006, 08:39

finished clearencing for the 915 box.
torsion tubes in place 5mm needs to be removed from the inside edge
new handbrake tubes need to be made.

cheers malcolm

ricola · #3 September 12th 2006, 04:06

Looking good Malcolm

Are you going to bridge over and under the trans to tie the two sections of torsion bar housing together?
Rich

56oval · #4 September 12th 2006, 06:52

rich I will over the top ,the bottom if I have enough clearence to remove the transmission.

Humble · #5 September 14th 2006, 01:49

I thought I had a lot of fabrication in my project but when I look at what your doing my car isn't so tough anymore

Keep the updates coming!

56oval · #6 September 16th 2006, 08:51

heres the bracing to bridge the torsion tubes together and the engineer has approved it.

this will be the position of the drive shafts under load.
[IMG]http://i55.photobucket.com/albums/g158/malcolm_05/IMG_1041.jpg[/IMG

cheers malcolm

56oval · #7 September 16th 2006, 08:53

another angle

cheers malcolm

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)