my 56 money pit

[56oval]

finished clearencing for the 915 box.
torsion tubes in place 5mm needs to be removed from the inside edge
new handbrake tubes need to be made.



cheers malcolm

[ricola]

Looking good Malcolm Are you going to bridge over and under the trans to tie the two sections of torsion bar housing together?
Rich

[56oval]

rich I will over the top ,the bottom if I have enough clearence to remove the transmission.

[Humble]

I thought I had a lot of fabrication in my project but when I look at what your doing my car isn't so tough anymore Keep the updates coming!

[56oval]

heres the bracing to bridge the torsion tubes together and the engineer has approved it.


this will be the position of the drive shafts under load.
[IMG]http://i55.photobucket.com/albums/g158/malcolm_05/IMG_1041.jpg[/IMG

cheers malcolm

[56oval]

another angle


cheers malcolm

[ricola]

Looking good Malcolm, but I think you could get a LOT more strength into the middle by closing off the hole infront of the trans...
Rich