Where I'm at so far...

[yetibone]

It's a good thing that primer was all gooped up in the bottom of the can on Saturday...

I just got off the phone with the fellow that painted my TR6. After he got my gallon of primer back to a homogenious liquid, he talked with the Evercoat tech rep regarding Slicksand's adhesion to acid based etch primer...a question I had after reading the label.

Turns out, it won't stick. Since Slicksand is polyester based, it cannot get a chemical tooth into acid based primers, like body filler, and glazing putty can't. After curing, I would'ive been able to peel it off in sheets from anywhere etch primer is underneath.

So sometime before next weekend, I'll pick up some plain old 2K urethane primer.