IRS weld onto swing pan?

[Hoghead]

I need to do a 944 narrow arm conversion into a 66 swing arm pan. My problem is that I am in Thailand and getting a IRS Beetle to make a jig as shown in this thread is next to impossible.

Can anyone provide me with a drawing to construct a jig, sell me the same, or point me towards where I can buy something

Robert

[ricola]

I made mine from 944 parts, just had to add a spacer to allow for the different inner bushes..
Rich

[Panelfantastic]

If I had an IRS pan laying around, I would fab you up a pair .

These guys show a step by step using a homebuilt jig, they might sell the jig and the mounts?
www.blindchickenracing.com

Jeff-