Convert2.1 DJ engine to aircooled

[Sunroof53]

I really wanted to give this a go but those eccentric head studs are putting me off , also going back to 8mm studs .When i saw the eccentric head studs i wondered if the head could be slotted but i suppose they already tried that?? .
The plus for me would be an ally case and not to use a type 1 case as that was one reason i built a type 4 .No mention of tinware .If there is 12mm of jacket left on the case ,type 1 tins aint gonna fit so i am back in the realms of making tinware.
I'll do some more searching for completed engines .

Thanks

[Sunroof53]

Just been reading the oxyboxer forum.looks like a whole new world and a lot of machining!Still not sure about them really .I may just stick to type 4s.

[JIMP]

Or you can get -if you have to afford- the heads from gwd or JPM ready drilled for the wbx stud spacing and you're done

jpmotorsport.se
gwd-weiser.de

Friendly

Dimitrios

[Sunroof53]

Thanks ,the whole challenge for me is building something using the skills i have and a bit of creative imagination.Besides that my wife wont let me buy the nice ready made stuff