My Project....Superbeetle Conv. 2.4l wizh EFI

[maniac]

Engine is back in car and oilpresure ist fine...
cold engine= over 5bar
Next friday we will programing the EFI.
Car runs up fine already, only need to program some finetuning

bst regards
markus

[maniac]

**** happens...
at 3500 or lest at 5000 rpm, engine ecu gets offline...
no idea why....grrrr

think theres an electric bug in the system...alternator damaged no load
Sometimes the vr is not registring the tooth...


for the video-junkies.
Video "first run"

http://www.youtube.com/watch?v=gcRMUnd_A70

[volkdent]

You probably already checked this, but a bad ground (-) can be responsible for a lot of weird stuff.

Jason

[maniac]

After checking anything and optimizing the mapping, it never happens again.
ECU runs fine, generating VE Table at this time

All parameters looking good
Oilpressure is fine
Ignition runs good
VE table will be generating

[maniac]

Video Update
http://www.youtube.com/watch?v=4vTIV49uG18

[Humble]

So far so good! Sounds like you got a bit of a lifter tick or it needs a valve adjustment but other than that the motor sounds good

[maniac]

Originally Posted by Humble

So far so good! Sounds like you got a bit of a lifter tick or it needs a valve adjustment but other than that the motor sounds good

Engine runs about 200km yet.
Valve Adjustment is ok.

Lifter tick cames from the webcam lifter, strong valvesprings and chrommolys
Will drive this setup.
Think this ticking noise will gone after webcam lifter and camshaft runs in place.