GermanLook Forums  

Go Back   GermanLook Forums > General > Project Builds

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #11  
Old October 11th 2010, 16:31
Humble's Avatar
Humble Humble is offline
Registered User
 
Join Date: Jan 2003
Location: Boulder Creek, CA
Posts: 758
Got a little work done on the car this weekend. Crawled under there and tried to get the bolt out but it's too hard for the bolt extractor. I've got another pair of trailing arms on order so I'll swap it out to get to the next race. That should make getting the bolt out a bit easier as well.

Since I was under the car I swapped out the rear springs for some longer (9" vs 7") 550# springs so I can dial in some more ride height. I had some tell tale o-rings on the shock shaft and sure enough both sides had bottomed out. When the new racer's edge bolts come in I'll probably replace the driver's side for good measure. I also noticed that the new inner cv boots on both axles are toast, cracked and torn all the way through. I'm half tempted to drop the car off at the shop to take care of the fiddly stuff. :P
Reply With Quote
 


Currently Active Users Viewing This Thread: 3 (0 members and 3 guests)
 

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 23:00.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
© www.GermanLook.net 2002-2017. All Rights Reserved