|
|
|
|
#1
March 20th 2011, 03:52
|
|||
|
|||
|
Skirt of the Cylinder
Hi everyone, question, at the bottom of the Cylinder where it goes into the spigot. I have noted some cylinders having a machining out a dish like shape. What is the removal of metal for? These are not my cylinder that I am having made, but very close to them. My fins will have the same diameter the entire lenght.
Last edited by effvee; June 14th 2013 at 22:46. 
|
|
#2
March 25th 2011, 23:24
|
|||
|
|||
|
My Cylinders
Hi, well the machinst finished them. I told him to only machine one of the four cylinder with the clearence for number 3 cylinder, well he did all four the same way
   these are for my 88 stroke engine ************************************************** ***************************  see the machining at the spigot end? is this madatory? I will have Costa Mesa R&D finish hone to spec's i'll select a 12Ra and cyro treat them before I send them to U.S. Chrome. See the botom of the cylinder, should'nt I have a cutout for the counter weight to pass by? Last edited by effvee; March 25th 2011 at 23:53.
|
 |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Hybrid Mode
