944 Trailing arm axle conversion Question

[proughj]

ok so I went back to the add in which I bought the parts this is the list of what I bought


- 944T Front and rear Brembo calipers
- Bug front SS brake hoses
- 944T Rear trailing arms with urethane bushings for bug
- 4 944T brake rotors - quite rusty - I was going to get new ones from 944online. Up to you if you want these old ones.
- 944T Front hubs engineered for 1974+ 1303 by VDub Engineering, with heavy duty caliper brackets
- Installation instructions from VDub Engineering
- 944T Spring plates + bug urethane bushings (944T rubber bushings removed)
- 2 944 (non-turbo) Torsion bars 23.5mm
- 2 1974+ 1303 spindles
- Bug front wheel bearings
- 2 Modified swans to hookup 1303 parking brake cables to 944T parking brake
- 2 944T used rear shock absorbers (not shown)
- Most all fasteners required to install this setup on 1974+ 1303 (not shown)



I plan on using the turbo calipers up front, why wont the rear calipers work? also if the bias is so bad could I use a brake bias valve like the one made by willwood. also what is a tb cover plate? thanks for all your help