|
|
|
|
#1
March 31st 2013, 14:14
|
|||
|
|||
|
Do I need to run a CHT on each cylinder? If I just wanted to run a dual CHT gauge, which cylinders would I put the sensors on? Was it Cylinder #3 that runs the hottest? Should I put the sensors on #3 and #4 so I can see the delta between those two? This concerns me because then I have no information about the right side of the engine... Those quad CHT sensors are expensivo!
|
 |
| Currently Active Users Viewing This Thread: 4 (0 members and 4 guests) | |
|
|
Hybrid Mode
