|
|
|
|
#1
August 17th 2013, 11:31
|
|||
|
|||
|
Started on the cage today. With these holes I can lower the cage a bid and weld the up side.
 Bending the bends in the wright position and keeping it straight is a PITA.  Did you see my special cupper angle measure tool ;D Paul.
__________________
If some is good and more is better, then too much should be just about right! 
|
|
#2
August 21st 2013, 08:10
|
|||
|
|||
|
De first hoop is in.
  I made the connection to the gearbox mount with tape, this way I can measure the angle I need.   Paul.
__________________
If some is good and more is better, then too much should be just about right!
|
|
#3
August 28th 2013, 15:56
|
|||
|
|||
|
Cage fight
    Paul.
__________________
If some is good and more is better, then too much should be just about right!
|
|
#4
September 8th 2013, 07:14
|
|||
|
|||
|
DAMN, why didn't I notice this before. After checking the cage measurements, I found out that the gearbox wasn't in line with the middle of the car.
 So time to start over again. (attempt nr. 3)   Paul.
__________________
If some is good and more is better, then too much should be just about right!
|
|
#5
September 9th 2013, 02:38
|
||||
|
||||
|
Noooooooo! Oh, you mean the tranny mounts, ok, I had a flash of you starting over on everything, just don't know if I could handle it!
__________________
If I could just get paid for my sleepless nights.... 1960 VW Bug UBRDUB Walkaround 1st Drag Run Dyno Run Oval Ragster-'57 Rag/'04 Boxster S
|
|
#6
September 9th 2013, 17:03
|
|||
|
|||
|
Quote:
Paul.
__________________
If some is good and more is better, then too much should be just about right!
|
 |
| Currently Active Users Viewing This Thread: 3 (0 members and 3 guests) | |
|
|
Hybrid Mode
