|
|
|
|
#1
November 11th 2007, 05:36
|
|||
|
|||
|
i'd only be interested in doing a one-off production of it for my own use, so its easier to adjust the toe angles and cheaper than off the peg ones (hopefully)
chris 
|
|
#2
November 11th 2007, 14:58
|
|||
|
|||
|
No longer
Hi, sorry for budding in, but I don't need a file. I just need one for a type 2 or type 1. I plan on graphing a type 2 rear suspension for an automatic to my 1303, so thus the need for a possible type 2 one. You said you did the work in class, how about a group buy and you allowing one person do the project with your premission?
|
|
#3
November 11th 2007, 15:01
|
|||
|
|||
|
[QUOTE=effvee;62360]Hi, sorry for budding in, but I don't need a file. I just need one for a type 2 or type 1. I plan on graphing a type 2 rear suspension for an automatic to my 1303, so thus the need for a possible type 2 . You said you did the work in class, how about a group buy and you allowing one person do the project with your premission?
|
|
#4
November 11th 2007, 15:12
|
||||
|
||||
|
I could like a project where a "limited edition" of parts is made up for sale.
But the goal had to be that it was a reasonable prised part where only costs for producing and shipping the parts where charged. And for cost reasons it probably had to be made in china, to specs and drawings from a project group. Personally i would only contribute with drawings and specs for material. and my only charge in a project like this is a kit for free. It should be possible to make a kit for around 100$ in a low cost country. i'm in it for the entusiasts only! Last edited by Turbo Haraune2; November 11th 2007 at 15:14.
|
|
#5
November 11th 2007, 15:48
|
|||
|
|||
|
Turbo Haraune2 : Hi, if you decide to release your cad drawings for a one off production with a bit of mods for alloy arms, my email address
chrisbro77@hotmail.com.... Only way to do it is to try and copyright them and have a clause can be produced but only by say so from yourself... chris Can i ask did you have the idea of the whale tail from the very start ?
|
|
#6
November 11th 2007, 16:04
|
||||
|
||||
|
Im also installing the alu arms this winter so i wil see what mods needed to fit.
Im sure we can make a deal about the drawings... but i want to fine tune them first. The whale tail was there from the start.. but this winter it has to go, in favor of a much bigger intercooler and alu ving from bigwig. Quote:
|
|
#7
November 11th 2007, 17:26
|
|||
|
|||
|
As far as i know the spring plates on the alloy arms bolt the opposite side of the trailing arm to the steel ones.....
also the bolt pattern is different, so it may just be a case of flipping the bolting plate to the other side of the arm.... dont know just a thought cheers chris
|
 |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Hybrid Mode
